... retrieving film from a cassette into which you had inadvertently rewound the film as you were switching from one film ... uses two-sided sticky tape which ...

... Making a film retriever to use when you need to retrieve film that you have rewound completely ... and stiff as Dymo label tape, but the swollen emulsion on scrap film ...

... one uses two-sided sticky tape which is applied to a piece of film and inserted ... This places the retriever under the film's leading edge and some of the ridges ...

When you point a tape-covered plastic camera at someone, the reaction you get ... The method I use to expose film in this adaptation is to wind a frame, expose by ...

Rather than buying a fancy film retriever, can I use a bottle cap opener to pry ... I have always pulled the leader back into the cassette when I rewind film. ...

b)Use a film leader retriever to pull the leader back put of the cassette. ... reach the end cut the film leaving any tape that was holding the film on the reel. ...

BTW, you are using a "weird a.s kroatian film" in sheets ... spool end to rewind the film so that it drags the labeling tape into the. cassette. ...

DIY 35mm Film Retriever - Step 4: apply new masking tape ... cut out ~1.5cm x 1.5cm squares on the film strip using the masking tape as guides. ...

... film retriever to use when you need to retrieve film that you have rewound ... I do this is that the shear strength of the tape "connection" is very great. ...

Retrieving fully rewound film ... A film leader retriever does take a bit of fiddling but would ... it a few times back toward yourself..then using some stiff tape ...